Active Data Series:
File Preview
Execute custom instructions on a single click. Ideal for configuration commands or testing microcontrollers.
| CAN-ID | Type | Length | Data | Cycle Time (ms) | Count |
|---|
| On | CAN-ID | Type | Length | Data | Cycle Time | Count | Comment |
|---|
| Time | Dir | Raw (hex) | Decoded |
|---|
| Name | Start | Len | Order | Sign | Factor | Offset | Min | Max | Unit | Receivers | Plot |
|---|
CAN Output
Protocol Definition
Save the full mapping (both sections below) to a named file once the client's protocol is defined, and load it again next time.
CAN Output (TX) — Control Signals
Map each signal to a CAN-ID and bit position, and to either a live control or a fixed constant. Several signals can share the same byte. Feeds the "CAN Output" card on A/C Control.
| Name | Source | Value | CAN-ID (hex) | Ext | Start Bit | Length | Order | Sign | Factor | Offset |
|---|
CAN Input (RX) — Diagnosis Signals
Define any number of signals to decode from incoming CAN traffic. Feeds the "Diagnosis" panel on A/C Control, and can also be sent to the Real-Time Plotter.
| Name | CAN-ID (hex) | Ext | Start Bit | Length | Order | Sign | Factor | Offset | Unit | Plot |
|---|
ESP32 Programmer
Pick the folder containing bootloader.bin, partitions.bin and firmware.bin, then press Flash. Addresses are set automatically (bootloader depends on the detected chip, partitions at 0x8000, firmware at 0x10000). It uses its own serial connection: disconnect the main Console connection first.
| File | Flash address | Size | Status |
|---|